Old Victorian Hallway Covered in Carpet Glue Fully Restored in Brighton

The 19th century was a pivotal period for the Brighton and Hove area of East Sussex. Many of the major attractions were built during the Victorian era, including two of the major piers. Over time, Brighton became not just a very popular destination for day trippers, but also for home makers. Lots of Victorian-style houses were built, complete with Victorian-style tiled floors.

Modern homeowners are increasingly uncovering these original Victorian tiles after decades of being hidden under carpet overlay. Contrary to popular belief, it is very much possible to restore these tiles back to peak condition despite suffering from damage, dirt and staining.

Victorian Tiled Hallway Floor Before Restoration Hove

I recently a house in Brighton to prove just that. The customer’s Victorian tiled hallway floor had been covered by many carpets over the past few decades and so there were many thick glue deposits, along with a heavy build-up of dirt and staining.

Victorian Tiled Hallway Floor Before Restoration Hove

Cleaning an Original Victorian Tiled Hallway

After protecting the woodwork with tape, I set about cleaning the Victorian tiles using a combination of products. One of these was Tile Doctor NanoTech HBU (HBU = Heavy Build-Up Remove), a powerful cleaner which uses nano-sized cleaning particles to penetrate deep into the tile to lift out and dissolve ingrained dirt and stains. I mixed the NanoTech HBU together 50:50 with Tile Doctor Pro-Clean, a reliable alkaline-based cleaner. This cleaning mixture was applied to the hallway floor and then covered with a plastic sheet for a few hours before being scrubbed into the tiles thoroughly with a lot of elbow grease and a specialised scrubbing pad.

Victorian Tiled Hallway Floor During Restoration Hove

A lot of the glue deposits were stubborn and would not respond to the chemical cleaning, so I needed to carefully scrape these off by hand. Once the majority of the glue had been removed I applied a set of diamond-encrusted burnishing pads to remove the top layer to resurface the floor and bring back a lot of the definition in the tile.

Victorian Tiled Hallway Floor During Restoration Hove

Sealing an Original Victorian Tiled Hallway

After completing the cleaning process, I left the floor to dry completely. Giving the tiles enough time to dry is important, especially in older properties which won’t have a damp-proof membrane installed. Even a small amount of excess moisture can cloud the sealer and damage its performance.

Once I was satisfied with the moisture level, I proceeded to seal the tiles using numerous coats of Tile Doctor Seal and Go which is a water based sealer that doesn’t leave a smell as it dries and as well as adding a layer of protection to the tiles give an appealing low-sheen finish.

Victorian Tiled Hallway Floor After Restoration Hove

The client, being of French nationality, said she was “sur la lune” (over the moon) with the result! Look at the photos below to see the transformation – I must say I was quite pleased myself!

Victorian Tiled Hallway Floor After Restoration Hove

 
 
Source: Victorian Cleaning and Renovation Service in East Sussex

Cleaning a Terracotta tiled floor in East-Sussex

The photograph below is from a Victorian tiled floor that we recently restored in the seaside town of Brighton. The house owner discovered the tiles under carpet and after realising what a beautiful and original feature they were decided to have them restored and so called in Tile Doctor. The tiles had been well preserved by the carpet although as you can see they were looking rather washed out and were in need of a thorough deep clean.

Victorian Tiles in Brighton Before Restoration

Cleaning Victorian Tiles

We set about cleaning the tile using Tile Doctor Pro-Clean which is a powerful alkaline cleaning product that is safe to use on tile and stone. It was applied with a mop and left it to dwell on the floor for ten minutes first in order to give it chance to soak into the tile and get to work on the dirt. It was then worked into the floor using a rotary machine fitted with a black scrubbing pad, stiff hand brushes and a substantial amount of elbow grease was used to tackle the stubborn stains and along the grout lines. The soiled water was picked up with a wet and dry vacuum and once we were happy the floor was clean it was given a thorough rinse with fresh water to remove any leftover chemical and then left to dry.

Sealing Victorian Tiles

Once the floor was dry we were able to seal it using four coats of Tile Doctor Seal and Go which adds a nice shine to the floor as well as providing a surface seal that will help protect the tile from stains going forward.

Victorian Tiles in Brighton After Restoration

It was quite a transformation and well worth the effort as you can see from the photographs above.
 
 
Source: Victorian Tile Restoration in Brighton