These photographs were taken at a large shared block of flats in the seaside town of Eastbourne. Recently a decision was made to replace the carpet in the entrance hallway and they discovered a lovely but damaged Victorian tiled floor underneath. A decision was made to restore the floor back to its former glory and we were asked to do the work.
Cleaning Victorian Tiles
The carpet had been stuck down with gaffer tape which is fortunate as sometimes a gripper rod is used with nails piercing the grout. To deep clean the heavy build-up of dirt from the tiles and remove the tape adhesive I applied a dilution of Tile Doctor Remove and Go combined 50/50 with Pro-Clean and left it to soak into the floor allowing it time to break down the glue. Over the course of the next two days the solution was scrubbed into the tiles, rinsed and then the soiled solution extracted and then re-applying until I was satisfied the floor was clean. It was a residential property and I couldn’t have anyone walking through the floor as I worked so I directed them up the fire exit. The kids really enjoyed the detour.
Sealing Victorian Tiles
Following 48hrs drying time I returned on what must have been the warmest day of the year to seal the floor with a shiny and hard wearing Tile Doctor sealer called Pro-Seal. Victorian tiles are quite porous so eight coats were required in the end.
The final result was a huge improvement and the residents continually commented on the change of colours. The whites really shone and who knew there were blue tiles there?
Source: Professional Tile, Stone and Grout maintenance service in East-Sussex
The pictures below are from a Victorian tiled floor installed in a period house in the coastal town Eastbourne. The tiles had been covered lino and carpet for years which the owner had only recently removed during renovation work, as it turns out this was unfortunate as they then became covered in plaster and paint from the decorators. Although the floor did look to be in a very sorry state I was very confident that I could breathe new life into it given enough time so I allowed four days to complete the task.
Cleaning a Victorian Floor Tiles
Some type of adhesive had been used to stick down the Lino and Carpet so the first step was to remove all the stubborn glue build up which I did using Tile Doctor Remove and Go, then once the bad areas had been targeted I concentrated on the plaster and paint build up which I treated using a 3-1 mix of Tile Doctor Pro-Clean in warm water worked in with a buffing machine fitted with a black scrubbing pad. The soiled water was rinsed away using a wet vacuum so the floor could be checked to see if more work was required which it was so stubborn areas that had resisted the initial cleaning onslaught were spot cleaned by using a diluted mix of Tile Doctor Grout Clean-up which is a very strong acidic product for removing grout and other mineral based substances from tiles. Before finishing the entire floor was given a thorough rinse to remove any trace of cleaning product, again a wet vacuum was used to remove the water and this time get the floor as dry as possible.
Sealing the Victorian Tiled Floor
The cleaning took place over two days and then the floor was given a further two days to allow it to dry fully after which I went back and sealed it with four coats of Tile Doctor Seal and Go which is an ideal sealer for Victorian tiles as it combines stain protection whilst giving the floor a subtle sheen appearance.
Looking at the floor when the last coat went on it was hard to believe the state it was in when I first arrived. Incidentally the owner who had inherited the house told me that he had not seen the floor look that good when his parents were alive as he remembered it from his childhood. It always makes the job more worthwhile when you hear stories like that.
Source: Tile, Stone and Grout Restoration Service in Sussex