The Victorian tiled floor shown below comprised of a complex square and diamond pattern contained with a parallel border and must of take a lot of work when it was first installed. It had been a while since it was last given a deep clean and was now looking rather dull and lifeless; we come across a lot of these floors at Tile Doctor and the remedy is a straight forward deep clean and reseal.

Victorian Tiled Floor Oxford Before Cleaning

Restoring Victorian Quarry Tiles

The first task was to clean the floor with a dilution of Tile Doctor Pro-Clean which was left to dwell on the tiles for a short while before being scrubbed in washing the floor down afterwards and extracting it with a wet vacuum to remove the soiled cleaning solution.

This did a reasonable job of cleaning up the tiles but there were some stubborn areas that would need further attention and what I suspected to be remnants of an old sealer. A stronger product was required and so the next step was to cover half the floor with Tile Doctor Remove & Go leave it to dwell for a time and then scrub the floor again with a rotary machine fitted with a scrubbing pad. Again the tiles were rinsed and the dirty cleaning solution removed using a wet vacuum. Once done the process was repeated on the other half of the floor. Working in sections like this allows more room in what was a tight hallway and also ensures the cleaning products don’t dry out.

This process removed all the old seal and drew out the ingrained dirt. I them rinsed the floor with a dilution of Tile Doctor Grout Clean Up to deal with a few stains and grout problems before removing it with the wet vacuum and giving the entire floor a thorough rinse with water which was repeated a couple of times; again the wet vacuum was used to extract the water from the tiles and get them as dry as possible.

Sealing Victorian Tiles

I had finished cleaning the floor and so left for the evening returning four days later to seal the floor. Fortunately the customer had planned a short break away so the tiles were nice and dry and still clean on my return.

To seal I applied a single coat of Tile Doctor Colour Grow which is an impregnating sealer to give a good base followed by three coats of Tile Doctor Seal & Go which is a topical sealer that added the shine the customer required.

Victorian Tiled Floor Oxford After Cleaning

 
 
Source: Tile Cleaning and Sealing Service in Oxfordshire